GGM BLDC Motor(DC Input Type)
| Product Name | Rating Output (Cont) |
| Round Shaft Type | W |
| K6LS30N2 | 30 |
| K8LS50N2 | 50 |
| K9LS100N2 | 100 |
| Power Input | |||
| Rating Voltage V |
Rating Voltage Allowance |
Rating Input Current A |
Rating Output Current A |
| DC 24 | ±10% | 2.1 | 3.7 |
| 3.1 | 5.4 | ||
| 6.0 | 9.8 | ||
| Rating Torque |
Starting Torque |
Rating Rotation Speed |
Speed Control Range |
| N·m | N·m | r/min | r/min |
| 0.12 | 0.15 | 2500 | 100 ~ 3000 |
| 0.2 | 0.24 | ||
| 0.4 | 0.5 |
| Allowed Inertia Load of Moment Round Shaft Type |
Speed Change Rate |
|||
| J×10-4 kg·m² |
J×10-4 kg·m² |
Load | Voltage | Temperature |
| 1.8 | 0.086 | Less than or equal to ±1%: condition o-rated torque, rated rotation speed, rated voltage room temperature |
Less than or equal to ±1%: condition rating voltage ±10%, rating rotation speed, no load, room temperature |
Less than or equal to ±1%: condition surrounding temperature 0~+40℃, rating rotation speed, no load, rating voltage |
| 3.3 | 0.234 | |||
| 5.6 | 0.611 | |||
| Product Name | Specification |
| Rotation speed setting method |
Controller panel’s speed control volume |
| Acceleration time deceleration time |
0.5~10 seconds : set at 2500 r/min when there is no load (it may change depending on the size of the load) Acceleration time and deceleration control equipment to control at the same time |
| Input signal |
Internal full-up input method, external input voltage read as greater than 2V high(off) same at all input ports |
| Output signal |
Open collector output, common for speed out/alarm out, if input voltage from outside is applied to connector #2 pin, then it comes out through the applied power. Everything else is internal 5V output UI (CTRL) |
| Protection function |
If the following protection mode comes on, control unit alarm signal is shown. Motor stops automatically. ㆍOverload protection mode : If torque that is greater than the rating is applied to the motor for more than 5 seconds ㆍOvervoltage protection : If voltage applied to the control unit goes over the upper bound of the rating voltage allowance ㆍOpen phase protection : If cable sensor line gets disconnected during motor operation ㆍUndervoltage protection : If voltage applied to the control unit is less than the lower bound of the rating voltage allowance ㆍOver speed protection : If motor rotation speed is faster than 2500 r/min |
| Motor insulation class |
E TYPE (120℃) |
| Maximum extension distance |
MOTOR – CONTROL UNIT 2m |
| Rated time |
Continuous |