I-Motion | Just another WordPress site

Motor Allowed Load Inertia Moment		Speed Change Rate
J kg·m²	GD² kgf·cm²	Load	Voltage	Temperature
0.5×10^-4	2	Less than or equal to ±1% (0~Rating torque, If rotating at the rated speed)	Less than or equal to ±1% (Power voltage ±10%, If rotating at the rated speed No Load)	Less than or equal to ±1% (0~+40℃, If rotating at the rated speed No Load)
1.8×10^-4	7.2
5.8×10^-4	23.2
5.8×10^-4	23.2
6.0×10^-4	24

Items	Specifications
Rotating Speed Setting Method	Controller panel’s speed
Acceleration Time Decelaration Time	0.5~10 seconds : 2000 r/min no load (It may change depending on the load size) To set acceleration time, it’s set at slow start on the front panel To set deceleration time, it’s set at slow stop
Input Signal	Photo coupler input method, operating at input resistance of 10㏀ DC 12V±10%, Common in EXT, CW, and CCW
Output Signal	Open collector output, External use conditions : less than 26.4V 10㎃, common in SPEED OUT/ ALARM OUT
Protection Function	If the following protection function is operating, then control unit alarm signal gets generated and motor stops automatically.Overload protection function : If more than the rated torque is applied to the motor for more than 5 seconds Overvoltage protection function : If voltage applied to the control unit goes over the upper bound of the rating voltage allowance Open phase protection : If cable sensor line gets disconnected during motor operation Undervoltage protection : If voltage applied to the control unit is less than the lower bound of the rating voltage allowance Over speed protection : If motor rotation speed is faster than 2500 r/min
Motor Insulation Class	E Type (120℃)
Maximum Extension Distance	The distance between motor – control unit is 10.5m (optional KBEW-10 extension cable is used)
Rated Time	Continuous